Thermon ET-7C User Manual download pdf

Tools Required

Applications

ET-7C

Installation Instructions

2 2 Tape Strips

3 1 RTV Tube

Item Qty Description

1 1 End Cap

Kit Contents:

The ET-7C Kit is used for end circuit termination of FP-BN con-

stant watt heating cable.

Due to the risk of electrical shock, arcing and re caused by product

damage or improper usage, installation or maintenance, a ground-fault

protection device is required.

Installation must comply with Thermon requirements and be installed

in accordance with the NEC, CEC, or any other applicable national

and local codes.

Component approvals and performance ratings are based on the use

of Thermon specied parts only.

Keep ends of heating cable and kit components dry before and during

installation.

Warnings

End Termination Kit

IP66 NEMA/Type 4X

Ordinary & Hazardous Locations

Listed Heat Tracing Cable System 137M

Certications vary by cable type. See product

specication sheets for additional information.

Certications/Approvals

4 1 Lug

IECEx

1 2 3 4

Summary of Contents

Page 1 - Installation Instructions

Tools Required 1Applications ET-7CInstallation Instructions2 2 Tape Strips 3 1 RTV TubeItem Qty Description1 1 End Cap Kit Contents:The ET-7C

Page 2

Installation Instructions for FP-BN Cut and remove primary insulation jacket.Cut and remove heating element and berglass over-lay. Push any remainin

Page 3

3 5. 6. 7.Stagger cut one of the bus wires. 8.Tape bus wires individually and then together. Continue taping to cover overjacket.Apply a liberal amoun

Page 4 - Thermon Manufacturing Company

Cable Take-off for FP-BN 4Part No. 50070-1106Thermon Manufacturing Company100 Thermon Drive • P.O. Box 609 • San Marcos, Tex

Comments to this Manuals

No comments

Thermon ET-7C User Manual

Browse online or download User Manual for Hardware Thermon ET-7C. Thermon ET-7C User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Hardware Thermon ET-7C